One of the most popular traditions of Christmas is decorating the Christmas tree. We all have the memory of our deranged parents wrapped in a lot of wires and lights for the tree. But, although it seems a complicated task. Actually placing the Christmas tree lights on the tree can be very simple if you follow the appropriate steps. It is very important that you take the correct precautionary measures to prevent children from getting hurt. Or yourself getting hurt by the poor condition of the bulbs. If you want to know how to place the lights on the Christmas tree. Then in this article of how we show you the steps. When you have your Christmas tree mounted. And ready to start decorating it is the time to prepare the Christmas lights. The number of lights should depend on the height of the tree.
When choosing the lights of the tree, keep in mind the rest of the ornaments of the Christmas tree to select them together with the decoration. It is very important to check the status of the lights for the Christmas tree in order to avoid possible damage. To do this, connect the cable to the power supply. And make sure that all the bulbs light up and that there are none in bad condition or broken. Pay attention, also, to the cables, make sure they are not damaged. Once all the checks have been made, we can begin to place them. Always start from above. So, tie the end of the cable to the tip of the tree and begin to lower it around the tree, as in a spiral.
24 Photos Gallery of: Follow This Tips And Get Gorgeous Christmas Tree Lights
To give volume to the tree and make it look more beautiful, place the lights from the inside out. So that they are at the tips of the branches. And give a feeling of greatness. It is very important that the lights are not too deep inside the branches of the Christmas tree. Because otherwise the opposite effect will be created. It is recommend that you place the Christmas tree lights disconnect from the current. To avoid disassembling them if the final result you do not like, you can connect them during the process. So, when you have put the lights on the first branches. Stop for a moment, turn them on and see how they are doing. Place the lights on the tree evenly until you reach the end. Once all the lights are on, connect them and check the final result.