Hanging a frameless bathroom mirror is a simple project that takes only a few minutes. Whatever the shape, smooth or ornate brackets called mirror clips quickly and safely attaches the mirror to the bathroom wall. Mirror clips are typically made of steel, brass, tin and plastic. Unless the mirror is particularly heavy, four mirror clips usually suffice to hang the most frameless mirrors.
Place the frameless bathroom mirror wall where you intend to install it. Rest a water pass on any horizontal surface of the mirror. Adjust the mirror position, if necessary to straighten the mirror. Track a weak line with a chalk lead on the wall, specifying the location of the upper and lower edges mirror. Keep the water pass vertically on the wall 2 to 3 inches from the left edge of the lines on the wall. With that level vertical, mark the points where the level crosses the chalk lines. Repeat to mark lines on the right side of the lines.
12 Photos Gallery of: Hang A Frameless Bathroom Mirror
Then to hang a frameless bathroom mirror, place the point on the cylinder on a lower pilot hole mark. Use a hammer to knock the needle, make a hole through the plaster. Since the power mirror clip is vertical, it is not necessary to screw them into the frame studs or use wall anchors. Repeat to make a pilot hole through the middle of the mark on the lower edge. Fit the lower mirror clip. Align the screw hole in the mirror clip to the pilot hole. Using a screwdriver and screw included in the kit, screw the clip to the wall. Repeat to install the remaining lower clip.