Flush mount light fixtures – Install flush mount lighting is a great addition to most homes. You can change the look of a room by simply changing the lighting in the room. Turn off power supply. Always check that the power is off before tampering with the wiring.
Cut the hole. Highlight areas of the roof where you want to install the lights. Position light between the joists where the wires run. Using the template that comes with flush mount light fixtures, light tracing the circle of your designated location. Using a utility knife, carefully cut out the circle. It is important that the circle is very accurate. Locate the electrical wire and gently pull the cable from the ceiling through the hole, leaving 16 inches of extra cable.
12 Photos Gallery of: Installing Flush Mount Light Fixtures
Wire your light. Remove the plate from the light switch box and safely insert a cable in the box. Using wire nuts, tape 1 inch from the cables and clamp them to the wires in the junction box. Place the cables in the junction box and snap on the cover. Install light. Place the light in the hole and tighten the flush mount light fixtures in place. Add the trim. Unscrew bulbs. Turn on your power source.